Too Kool Recreation umbrella clamp for pool and spa

1. Lift banana shaped handle on Kool Klamp. tm Slide the Kool Klamps tm on to the bottom umbrella pole. IMPORTANT leave banana shaped handle up and loose so you can adjust Kool Klamp later.
2. Find the location where you want to put your shade system. IMPORTANT If you have a plaster pool you may need to smooth(sand) a small section of the wall just where the Kool Klamps will be. Approximately 10 inches wide by 20 inches deep. This should only take about 5-10 minutes. The top Kool Klamp should be about 2 inches below the tile line. The bottom Kool Klamp should be about 3 inches below the top Klamp. Hold the pole in the location you want. Always engage bottom Klamp first! IMPORTANT Push the suction handle in firmly towards the wall then push it sideways to engage the powerful hold.
3. Repeat the same steps on the top Kool Klamp.
4. Push both banana shaped handles down to secure umbrella pole. The pole should feel firm in the Klamps.
5. When bottom pole and Klamps are set firmly into position, open the umbrella and set into the bottom pole. Pull lever down to secure.See Pic # 50.		PIC #50
6. To remove Kool Klamps release suction handle. Then slide fingers under pad to break the suction seal.
WARNING Always wear sunscreen, even under a Too Kool Recreation tm shade system. Do not use in windy conditions.
Care and storage. Remove when not in use. When Kool Klamps are not in use, suction handle should be left open.
Return policy & product guarantee
If you are not satisfied with a purchase simply return it where you purchased it within 60 days for a full refund.(with receipt) If your purchase was off the internet, return the product within 60 days for a full refund of purchase price. (shipping cost are not refundable) Use our return form Click Here
If your product was damaged during shipping notify us immediately at (928)768-1970.
Our refund policy does not cover products damaged due to neglect, improper usage or application. Wind damage is not covered.

1. Lift banana shaped handle on Kool Klamp. tm Slide the Kool Klamps tm on to the bottom umbrella pole. IMPORTANT leave banana shaped handle up and loose so you can adjust Kool Klamp later.

2. Find the location where you want to put your shade system. IMPORTANT If you have a plaster pool you may need to smooth(sand) a small section of the wall just where the Kool Klamps will be. Approximately 10 inches wide by 20 inches deep. This should only take about 5-10 minutes. The top Kool Klamp should be about 2 inches below the tile line. The bottom Kool Klamp should be about 3 inches below the top Klamp. Hold the pole in the location you want. Always engage bottom Klamp first! IMPORTANT Push the suction handle in firmly towards the wall then push it sideways to engage the powerful hold.

3. Repeat the same steps on the top Kool Klamp.

4. Push both banana shaped handles down to secure umbrella pole. The pole should feel firm in the Klamps.

5. When bottom pole and Klamps are set firmly into position, open the umbrella and set into the bottom pole. Pull lever down to secure.See Pic # 50.

PIC #50

6. To remove Kool Klamps release suction handle. Then slide fingers under pad to break the suction seal.

WARNING Always wear sunscreen, even under a Too Kool Recreation tm shade system. Do not use in windy conditions.

Care and storage. Remove when not in use. When Kool Klamps are not in use, suction handle should be left open.

Return policy & product guarantee

If you are not satisfied with a purchase simply return it where you purchased it within 60 days for a full refund.(with receipt) If your purchase was off the internet, return the product within 60 days for a full refund of purchase price. (shipping cost are not refundable) Use our return form Click Here

If your product was damaged during shipping notify us immediately at (928)768-1970.

Our refund policy does not cover products damaged due to neglect, improper usage or application. Wind damage is not covered.

Too Kool Klamp

Installing Instructions